Start with an observer

An observer listens through a MeshCore radio and sends network data to CoreScope. It does not route mesh traffic. It can run on radio firmware, an always-on computer, or a home-automation host.

Read what the service collects and who can access it before enabling an observer.

Before you start

• Open the observer method chooser.
• Pick a method that matches the radio, operating system, and host you already have.
• Back up configuration before replacing firmware or installing a service.
• Use a real nearby location code when the chosen method asks for one.

What setup changes

Depending on the method, setup may replace radio firmware, install a host service, or add a home-automation integration. It also enables public network data publishing.

Setup checklist

Checks are saved only in this browser.

1. Read what observer data becomes public
2. Choose a supported observer method
3. Back up and prepare
4. Follow the selected setup guide
5. Apply local radio and service settings
6. Check that the radio hears nearby activity
7. Find the observer in CoreScope

Set up the observer

Use the observer method chooser, then follow only the guide for the selected method.

Use the right radio settings

The connected radio must use the same settings as the nearby mesh. Start with USA/Canada (Recommended) and the 3-byte path setting unless your community lists different settings.

Match your local mesh

Check the community directory. A connected observer can be online while hearing no useful traffic if its radio settings do not match nearby devices.

Make sure it works

The observer is working when:

1. its radio hears known nearby mesh activity;
2. it appears in CoreScope Observers; and
3. recent activity appears after a nearby transmission.

Use the observer verification checklist.

What's next

Check the observer after radio, network, credential, host, or firmware changes. Open Check your observer for the detailed health view. If it is missing or quiet, get help.